Set up
Scanners
Pair a Bluetooth barcode scanner and test it, for faster ticket and code scanning.
The Community Portal can scan with the device’s camera. A Bluetooth barcode scanner makes it quicker, especially at a busy event door. You can use one to:
- Scan tickets in Event check-in.
- Scan gift cards and rewards codes in Point of Sale.
- Scan the Admin access code to leave the Guest Form kiosk on an iPad.
Pair the scanner
Pair it in the device’s Settings
Open the iPad or iPhone’s Settings → Bluetooth and pair the scanner. Scanners connect as a keyboard. In the Community Portal, Settings → Scanner → Pair in Settings opens the Settings app for you.
Set it to send a return
Configure the scanner to send a carriage return (Enter) after each scan. Your scanner’s manual has a code to scan for this.
Check that it’s detected
Open Settings → Scanner. Keyboard shows Detected when a scanner (or any keyboard) is connected, or None Detected when nothing is.
Do a test scan
Select Test Scan. When you see Ready to Scan, scan any barcode. The code you scanned shows on screen.
- Scan Received: it ended with a return, so it’s set up correctly.
- No Return Detected: it read the code but didn’t send a return. Set the scanner to send one, then test again.
- No scanner detected: pair it in Bluetooth settings first.
Detected only means a keyboard is connected. Run Test Scan to be sure it’s your scanner and that it sends a return.